propmaster2000
Sr Member
I was thinking "the added lip" would be more about light bleed through the gap the two parts create,It's the warping that's the problem because the model is a large, open, relatively thin part which isn't suited to a resin 3D print. Even if there was a lip, if the part is warped it won't keep the parts together with only 4 corner screws.
I'm going the PETG or Nylon route given its structural benefits and rigidity which is better suited to thinner parts.
not fixing the warp that shouldn't be there.
.
Of course, they would have to be printed without the warp in the first place.....
Anyway, good luck.
.
Last edited: