The Nameless One (Planescape: Torment)


New Member
That was my first attempt to make a miniature (20 cm height) of 'Planescape: Torment' main character The Nameless One. It's a plasticine figure and later I will make a silicone cast to be filled with plastic.


This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.