Hello everyone,
Just a quick update for today.
We are adding the final accuracy touches to our hilt as we get closer to anodizing. We have added the last detail needed so that our hilt can be as accurate as possible. We have also just finished some 3d modeling to assist the anodizing shop in getting the two-tone effect. We believe it is going to have enough contrast to be noticeable but not at the expense of accuracy. Here is a picture of the quick change we were able to get programmed and cut in a day with the capabilities of a 5-axis machine.
We will update here as soon as we get our anodizing samples back. Once we decide on the proper finish, we will give the anodizing shop the first batch of 25 which is estimated to take two weeks. After that we should be ready to ship!
We will post pictures as we get them!
Thanks again,
Malibu
Just a quick update for today.
We are adding the final accuracy touches to our hilt as we get closer to anodizing. We have added the last detail needed so that our hilt can be as accurate as possible. We have also just finished some 3d modeling to assist the anodizing shop in getting the two-tone effect. We believe it is going to have enough contrast to be noticeable but not at the expense of accuracy. Here is a picture of the quick change we were able to get programmed and cut in a day with the capabilities of a 5-axis machine.
We will update here as soon as we get our anodizing samples back. Once we decide on the proper finish, we will give the anodizing shop the first batch of 25 which is estimated to take two weeks. After that we should be ready to ship!
We will post pictures as we get them!
Thanks again,
Malibu