Terminator update

iowadude41

Active Member
Hello everyone,
I have an update as of !-20-21...I took another long look at my chest cavity, and didn't like how it looked. I found a person in Australia I believe that built their own T-800. I asked for a couple measurements, and with their help, I finally got the correct ones which helped greatly! So with those, I cut the front and back plates apart, and cut out around 1.5" off each side which brought the thickness from front to back down to 8.5". Not the 7" it should be, but close enough. After re-gluing them back together I noticed the width was still around 13", and needed to be 15". So I heated both sides with my hot air gun, and reformed them which actually made it 15" wide. It looks so much better now. I did have a couple issues last week like the spine broke off the pelvis since my Terminator was in the outside garage in ice cold weather. I brought the whole thing into the house, and in doing so, the left foot fell off and the small pistons on the bottom of the foot broke off. Damn!!! Not to worry though as I fixed all that, and it's now all back together in a warm house.
I also bought, and received 2 different sizes of hydraulic hoses for the pistons, and also my Terminator skull kit finally arrived. So now I can work on more things since I'll be working inside where it's a lot warmer, and the PVC glue will not break apart. I'll update when more things get down.
In case no one has seen my chest cavity pics, I'll attach a couple here of how it looked, not how it looks right now.

Thanks for all your support everyone.
 

Attachments

  • IMG_20210108_175548.jpg
    IMG_20210108_175548.jpg
    251.3 KB · Views: 35
  • IMG_20210108_175619.jpg
    IMG_20210108_175619.jpg
    271.3 KB · Views: 45
  • IMG_20210108_175640.jpg
    IMG_20210108_175640.jpg
    254.6 KB · Views: 41
  • IMG_20210108_175702.jpg
    IMG_20210108_175702.jpg
    211.9 KB · Views: 41
This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top