Helix6187
Well-Known Member
Hi there !
A little bit of modelling done after watching T2 one more time.
I used pics from the hero prop found on the web on an auction site.
And then printed on my resin printer.
I need to clean them a bit since I printed them flat in two parts (no supports needed, and quicker this way) and brush them for removing what looks like dust,
the weather was wet when I'm primed them tonight.
I still have not found a clear view for damaging properly the "block" on the broken chip so for the moment it will stay like that.
Thanks for looking.
Helix
A little bit of modelling done after watching T2 one more time.
I used pics from the hero prop found on the web on an auction site.
And then printed on my resin printer.
I need to clean them a bit since I printed them flat in two parts (no supports needed, and quicker this way) and brush them for removing what looks like dust,
the weather was wet when I'm primed them tonight.
I still have not found a clear view for damaging properly the "block" on the broken chip so for the moment it will stay like that.
Thanks for looking.
Helix