SWTOR Jedi Temple Guardian and The Clone Wars version


BSD

Well-Known Member
RPF PREMIUM MEMBER
So I was asked by a friend of mine to build the Temple Guardian from Star Wars The Old Republic and then was also asked if I could do The Clone Wars version as well. So I decided to do both. Here are some pics of the models before I start the 3d print.

10497875_960696903942138_2710410223744739505_o.jpg


10407097_960696907275471_2354948007794345066_n.jpg


11046207_960696900608805_7390230471993859345_n.jpg


10947185_960696910608804_4741138074937278536_n.jpg


10995994_960696950608800_1815469097734576286_o.jpg


That was the SWTOR version her is The Clone Wars version

10428575_960697193942109_3667123409788251301_n.jpg


Most just paint the details on.. I made it a part of the helmet.

11021135_960697190608776_1777784171815187874_n.jpg
 
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.
Top