sword help

Thread starter xanatos1
Start date Jul 25, 2015

xanatos1

New Member

Jul 25, 2015

need some advice. just built a sword out of card stock problem is that due to the length of the sword it makes the hilt and handle wobbly what would be the best method to solve this. would it be to use fiberglass and resin or bondo or is the some other way to make the join stiffer. any help would be great.

This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.