Suggestions on Smooth Cast, Bondo, and Fiberglass

Derrezed

New Member
I've been doing alot of research this week, so far Smooth Cast 300 will be my resin for my project I'm going to do. Only problem is I feel as if the smooth cast will develop small cracks. Kept thinking of putting fiberglass cloth inside the helmet I'm building will making the helmet alot more sturdy and durable.
Any other suggestions on how you do your process ? :confused
 
This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top