darkev2
Well-Known Member
Alright I have a bit of an issue. I purchased a BSG S-01 prop a while back and well after some false starts I'm sitting down to make the pistol. Of course the thing had some flaws and one of the most obvious is the grips; specifically there is almost no distance between the molded in detail of the Grip Medallions and the Grip screws. In fact they are so close on one side that it almost looks like they overlap. Now I could easily fill both in with bondo and re-countersink and etc. but what do I do to recreate the pattern for that circular section of the filled in screw detail.
Here is a picture of what I want the finished grip to look like;
so you all can see the pattern I want to duplicate. The area doesn't have to be perfect (I figure I will run something (what I don't know) over the bondo I put in the hole before it fully sets to recreate the pattern. Thanks for any help or suggestions I can get; they will be GREATLY Appreciated!!!
Here is a picture of what I want the finished grip to look like;
so you all can see the pattern I want to duplicate. The area doesn't have to be perfect (I figure I will run something (what I don't know) over the bondo I put in the hole before it fully sets to recreate the pattern. Thanks for any help or suggestions I can get; they will be GREATLY Appreciated!!!
