Suggestion sub-forum for 3d models and 3d printing

Thread starter 350zTuner
Start date Oct 18, 2016

350zTuner

Active Member

Oct 18, 2016

I would love to get a sub-forum for 3d models and 3d printing. It gets jumbled into all sorts of places here. I have a few files Id like to share and it would be neat to have a specific place to check it out =]

This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.