stormtrooper 3d print accessories

Thread starter d503364
Start date Mar 29, 2022

d503364

Active Member

Mar 29, 2022

Hello,
I am working on an eva foam built of the ANH stormtrooper. I would like to make the accessory features (ab plate buttons and components, backplate "twinkies and donut", helmet aerators) using a 3d model but I am having a difficult time finding anything.
Does anyone know of where I could get just these pieces to print?

Your message may be considered spam for the following reasons:

Your new thread title is very short, and likely is unhelpful.
Your reply is very short and likely does not add anything to the thread.
Your reply is very long and likely does not add anything to the thread.
It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
Your message is mostly quotes or spoilers.
Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
This thread is locked.