Star Wars font.

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.


propmainiac

Sr Member
RPF PREMIUM MEMBER
Hi all
wanted to try my hand at making some display plaques for my Star Wars props. Now I've seen some around and I'm going to print my design on decal paper then stick it to aluminum plates. My question is this.... What is the font used on the master replica plates? I'm not doing this for profit or distribution just for fun? Also does any know anything about metal etching and would this be better for making a plaque. Thanks
 

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

Feezle-Nuts

Sr Member
RPF PREMIUM MEMBER
Trajan and Garamond. I think etching results would depend on the material you use. The aluminum I use for my plaques is quite thin.
 
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

Top