Staff of Ra Headpiece

ZMAN6

New Member
My first project upload here, :)
This was Resin Printed on an Anycubic Photon with elegoo gray resin. The file came from Thingiverse Head piece to staff of RA and staff mounting pieces by youngs66.
I finished it with Bronze rustoleum spray-paint base coat and then gold and silver rubnbuff.
The red "jewel" is plastic and came off of a candy skull Halloween decoration I found at the dollar store. The jewel was trimmed to fit.
I know its not as shiny gold as the one in the film but I'm really happy with how it came out.
I think I want to make the necklace with the coin and stones to go with it at some point.
 

Attachments

  • IMG_1015.JPG
    IMG_1015.JPG
    3.1 MB · Views: 53
  • IMG_1016.JPG
    IMG_1016.JPG
    3.1 MB · Views: 44
  • IMG_1017.JPG
    IMG_1017.JPG
    2.8 MB · Views: 43
  • IMG_1018.JPG
    IMG_1018.JPG
    2.2 MB · Views: 47

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.
Top