Splinter Cell suit

W4RH0US3

New Member
Hello I am making the wetsuit version of Sam Fisher's MV tac suit. I am pretty much finished with it except for one thing. The suit is a wet suit which means it is made out of Neoprene. With that said there are logos on it i would like to remove or paint over. Is there anyone here who can help me with this situation?
 
Will you actually wear this or will it be a prop? You can spray paint over the logos as that is most likely how they were applied in the first place.
 
Can't really help with covering of logos apart from spraying it. However it sounds really cool and would love to see pictures as you are making it :)

Thanks Amanda
 
I will be wearing the wetsuit so what would I need to do?
Short of painting over the logo, you could try some acetone [do a test first] as that removes almost everything. You just need to make sure that the neoprene is not affected by the acetone.
 
This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top