Spider-Man Suit

[Spiderpug]

Hey I was wondering if I could get advice on attaching my lenses to the mask. I don’t want a faceshell because it is just so inconvenient. But when people glue the lenses they can only place them once, and if you mess up that’s it. And it usually end s up bunching in the middle. I figured the solution for this is in the middle. To put magnets in the mask itself, so you can re adjust whenever you need to and can take out the lenses to see. I have seen one guy do this flawlessly on YouTube but I lost the video and can’t find it. Can anyone find the vid or give me advice? I was thinking about using magnet strips

 

[Spiderpug]

How would I attach my frames to my mask with magnet. No faceshell just the magnets. Like what glue? Has anyone else done this?

 

[Spiderpug]

Are spidey4fun’s raimi frames the best?

Are they atleast good?

 

[Spiderpug]

What glue would I use to bond my urethane spider to the chest of my suit? I don’t want it to end up hard and rough.

Also if spidey4funs chest piece the best one?

 

[masterjedi322]

I used a Superglue gel and put dots of glue in a few key spots to hold it on.

Sean

 

[masterjedi322]

"Best" is a subjective term depending on whether you're looking for accuracy, inexpensiveness, ease of assembly, etc.

I'm certainly not putting down s4f's stuff - it's great!

Another option you might want to consider is SpideyPlanet, whose frames and faceshell are available on Shapeways - SpideyPlanet on Shapeways

Sean

 

[TJackFx]

Gorilla glue works well to bond urethane to fabric