Reply to thread

Message: <blockquote data-quote="Blackbirdcd" data-source="post: 3870031" data-attributes="member: 2468">I am noticing a common mistake with the front part of these stun guns - the slab in front with the emitters is supposed to be slightly sloped on the emitter side (the outside if you will), while the inside is almost 90 degrees. People seem to be going the opposite of this, making the inside angled while the outside is flat. It's apparent in the screenshots of the hero prop that this is the case.Am I wrong in seeing this?Also, in spite of this detail nit, I really like the pieces shared in this thread. I'm more concerned that I get my own drawings accurate</blockquote>

This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

Your new thread title is very short, and likely is unhelpful.
Your reply is very short and likely does not add anything to the thread.
Your reply is very long and likely does not add anything to the thread.
It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
Your message is mostly quotes or spoilers.
Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
This thread is locked.