Snipex Alligator

Continuing with this project by using UV resin to fill in what layer lines sanding left. I also glued in the resin printed name plate on the magazine and filled the gaps. This will eventually be printed in a tan colour with some of the hardware painted steel.

IMG_1618.jpg


TazMan2000
 
Here are some finished photos. I used Tamiya TS3 Dark Yellow overall and that seemed to be almost an exact match for the real weapon even though the photos portray it as more yellow than it really is. I chose Rustoleum Chalked Cocoa Bean for the grip, cheek rest and the buttstock pad, but I'm really not happy with that since it dried a lot glossier than I expected and the colour was much lighter and intense than depicted on the cap, but I'm not changing it now.

868466FA-B470-467D-9816-0349F3669CED.jpeg
D6321DC7-8F69-473D-B462-D55BAAEB3C89.jpeg
DB273EEE-7DDA-4868-8B02-226AB6AA2D58.jpeg
CF1E8F08-1D88-4B85-A585-AB658CA60BF6.jpeg
361D82D3-6FA8-48F7-869C-9420F7C707F5.jpeg
D90D1ACC-E099-4C32-A860-34F13860CE47.jpeg


TazMan2000
 
TazMan2000 said:
An old musket or rifle would look great, but since this one is made mostly out of PLA, there would soon be a pile of goo over the mantle.

TazMan2000
Click to expand...
I dunno lol, I had the Black Spindle on the wall for a while, and it was PLA :lol: I channel my big guns for 3/16" steel rods, it has done great to combat PLA droop.

12512674_1590631354591739_1468249837589416406_n.jpg
 

Your message may be considered spam for the following reasons:

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

Similar threads

NewmanAssembles
Ghostbusters Utility Belt Red Alligator Clip
Replies
3
Views
667
Fett202
Fett202
Back
Top