'SLAVE 1' Studio scale build

SLAVE 1 FILES ARE NOW AVAILABLE VIA MY WEBSITE
HERE

53208040304_0d358218a7_o.jpg
 
Beautiful work. I love it. I don't remember if you mentioned it in your videos (I watched them as you released them), but what is planned for the canopy? Is it a also a part to print in clear resin or a plug for vacuum forming?
 
Wow! looks great. What printer did you use?
I used the Epax-X10, Epax-X1 and the Anycubic M3 Max.
The Epax are old printers but still can do some prints for the smaller parts.

I did remove a lot of the interior details, and only printed what can be seen through the cockpit.
Also remade certain parts, so I could hollow them out to save on resin.
and the tail parts were printed as 1 part, to save on work :)

Still working on the canopy vac form mold, the clear resin was not working as I wanted to :/
 

Your message may be considered spam for the following reasons:

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top