This forum is intended for interest gauging and active runs. Due to the transient nature of this forum, please keep all research and ongoing discussion in one of our main forums so your information is not lost.
Only Premium Members can start a new run.
as for the fiberglass resin part, any tips on how to do that? this would be my first time doing it. I haven't had an issue like this with any helmets I've had before, so I want to be as careful as possible moving forward.Sorry to hear that.. I havent had any issues so far, that is the best way to pack them by far...keeps the back the right width.
And I use loctite.. you will want to be careful how wide you start making the "wings" since they have to fit into the front piece proper.
Its odd that it just snapped off.. my shop copy has be dropped on concrete on numerous occasions and not very well taken care of..still like new.
And feel free to post up a paint up here.. I will do the same once I get the finishing work going full steam.. just way too hot at the moment [emoji14] 100.4 F last time I looked
I'm over cautious and have fiberglassed many times. If you've never done it before, then it would probably be an overkill in this situation...i'd take TheRocketeer advice on the epoxy [emoji106]
100° F? No thank you! [emoji28]Sorry to hear that.. I havent had any issues so far, that is the best way to pack them by far...keeps the back the right width.
And I use loctite.. you will want to be careful how wide you start making the "wings" since they have to fit into the front piece proper.
Its odd that it just snapped off.. my shop copy has be dropped on concrete on numerous occasions and not very well taken care of..still like new.
And feel free to post up a paint up here.. I will do the same once I get the finishing work going full steam.. just way too hot at the moment [emoji14] 100.4 F last time I looked
Looking good! that screen mesh goes behind the breather on the inside of the tube. You'll have to cut out the circle on the breather and place the mesh behind the lip and glue it in. I had to paint that area again due to me missing it the first time
I was literally just trying to figure this out, you saved me all the hassle. [emoji23]
No problem!
Yep im glad to let everyone learn from my mistakes haha
