Sagging MR plaques???????

[tubachris85x]

I have an MR clone helmet on display sitting on top of one of my stereo speakers, and over time, Ive noticed that one side of the plaque began to sag and it looks bad IMO.

I initially thought it was caused by the vibrations of the stereo, so I took it down, and removed the plaque, repositioned it and it was good, and everytime i want to use the stereo, I always took the helmet w/ stand down.

Now, Ive noticed that it has started doing it again and its really frustrating. Anyone know what I can use to fix this? Thanks!

 

[TridCloudwalker]

Scrape/rub off the adhesive with rubbing alcohol, scuff the areas up that touch with some 250 sandpaper, slap on a little dab of epoxy glue, clamp, allow it to dry, remove clamp, display anywhere you want, and send me $50.

 

[tubachris85x]

Scrape/rub off the adhesive with rubbing alcohol, scuff the areas up that touch with some 250 sandpaper, slap on a little dab of epoxy glue, clamp, allow it to dry, remove clamp, display anywhere you want, and send me $50.

lol, well, i can do everything but the $50, hope you can understand

Thanks, I'll get on that sometime soon then

 

[Cenobyte]

My clone stand does the exact same thing. I think the adhesive tape they used was not that good.

 

[Treadwell]

My clone plaque held for about a day. Bad batch of tape, I guess.

 

[KnightAsylum]

Viagra?

Sorry, bad joke I know.:rolleyes
My Clone one did that as well, I just pulled it away a bit and added a touch of Superglue:thumbsup