Velocity502
New Member
So I found this seller on Etsy by the name of SaberWerks. I'm thinking of buying a creepy uncle hilt from him and wondering if anyone here has had experience with this seller
SaberWerks
- Thread starter Velocity502
- Start date
Joek3rr
Master Member
He's just reselling a Korbanth LS6 with a very steep markup.
You can get it for way cheaper here
The Custom Saber Shop
If your set on a Creepy Uncle, I'd keep an eye on the Junkyard.
Or see if he makes more
Balance V4: FX READY EMPTY HILT - Roman Props | Roman's Empire
Aluminum LED Housing & Heat-sink M3 Blade retention screw (uses 1.5mm hex driver) Emitter Plug Copper Neck & Box details (clear-coat applied) Machine & Anodized finish Works w/1" thin-walled blade & LED w/hole in center of pad. e.g. tri-cree 1" slip-fit emitter shaft Two (2) Pommel Caps...
romanprops.com
His was the most accurate. Maybe he'll come around and do another run
Done / Completed - Luke Skywalker TLJ «CreepyUncle» lightsaber (by Lukyanov) Run #2
It will be the new one. I'll post the link here Thanks
www.therpf.com
Velocity502
New Member
Thanks! I'm still debating on it but it would be nice to have a hilt that good of qualityHe's just reselling a Korbanth LS6 with a very steep markup.
You can get it for way cheaper here
The Custom Saber Shop
www.thecustomsabershop.com
If your set on a Creepy Uncle, I'd keep an eye on the Junkyard.
Or see if he makes more
Balance V4: FX READY EMPTY HILT - Roman Props | Roman's Empire
Aluminum LED Housing & Heat-sink M3 Blade retention screw (uses 1.5mm hex driver) Emitter Plug Copper Neck & Box details (clear-coat applied) Machine & Anodized finish Works w/1" thin-walled blade & LED w/hole in center of pad. e.g. tri-cree 1" slip-fit emitter shaft Two (2) Pommel Caps...romanprops.com
His was the most accurate. Maybe he'll come around and do another run
Done / Completed - Luke Skywalker TLJ «CreepyUncle» lightsaber (by Lukyanov) Run #2
It will be the new one. I'll post the link here Thanks