Rocketeer / Iron Giant

FRANCK

New Member
Hello I'm french., In my garage i tried to construct the jetpack in aluminium and helmet in brass. I need more screen capture or 3d files in DWG, Sketchup. I try with screen shot of film but i don't have the good dimension. I have already construct the IRON GIANT but it was first test for THE ROCKETEER. How can i insert photo of my construction
 
IMG_20210306_111146.jpg
IMG_20210211_100935.jpg
IMG_20210131_204052.jpg
IMG_20210131_204102.jpg
 
What dimensions do you need? My helmet is cast off of a production made helmet.
Hi, I know this post is more than two years old and OP never responded, but I'd love to get some measurements from your helmet if you're still up for it!

I'd like to know any of these you'd be willing to measure:

- the widest length and the longest length as measured from the bottom (helmet's opening)
- the length between the inner eye rivets (measured from the rivet centers)
- the length between the lower and upper eye rivets
- the distance between a rivet's center and the edge of lens opening
- the inside radius of the air intake port
- the maximum thickness of the fin
- the thickness of the welded arches
- the distance between the chin and the bottom lip indentation
- the fin's length measured from the rear corner with the straight edge resting on the helmet's top to it's front edge
- any mouth grille measurements

Kind of a long list but really, any measurements will help! Thanks so much!
 

Attachments

  • insideDimensions.jpg
    insideDimensions.jpg
    206.4 KB · Views: 27
  • refMeasurements.jpg
    refMeasurements.jpg
    103.1 KB · Views: 29
Last edited:

Your message may be considered spam for the following reasons:

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top