gnolivos
Sr Member
ANNOUNCEMENT:
Version 1.05 is uploaded, at:
Jetpack 3D Printable Kit
Here are the release notes.
(V 1.04 was an internal release).
V 1.05
-Refined and reshaped center hull to be slightly narrower, and with properly angled flanges where they meet the tanks.
-More accurate "eye" orifices at the top of the hull.
-Minor dimensional modification to top Radiator to fit the new hull. Old radiator will fit with very minor sanding.
-Note that the upper and middle tank sections now have different rivet pattern hole locations due to narrower hull. All other parts not mentioned here are identical to V 1.03.
-Printed Parts (Main circular vent, and center Radiator "Part 3") are identical to previous version V1.03, without changes.
-THIS IS LIKELY THE FINAL RELEASE, unless any major issues are found.
Version 1.05 is uploaded, at:
Jetpack 3D Printable Kit
Here are the release notes.
(V 1.04 was an internal release).
V 1.05
-Refined and reshaped center hull to be slightly narrower, and with properly angled flanges where they meet the tanks.
-More accurate "eye" orifices at the top of the hull.
-Minor dimensional modification to top Radiator to fit the new hull. Old radiator will fit with very minor sanding.
-Note that the upper and middle tank sections now have different rivet pattern hole locations due to narrower hull. All other parts not mentioned here are identical to V 1.03.
-Printed Parts (Main circular vent, and center Radiator "Part 3") are identical to previous version V1.03, without changes.
-THIS IS LIKELY THE FINAL RELEASE, unless any major issues are found.