Rick and Morty freeze ray

matherton

New Member
Not long ago I completed a freeze ray for a friend, I was in a rush and only had a day to complete it so didn't document the process or think to post it here but I remembered!

I found the model on Thingiverse by Ramon Angosto, remixed by Nevaar. I scaled it up and printed it in PLA, sanded and painted it and added an led to the 'crystal' and hid the button on the bottom. piece.

As a finishing touch I modelled the stand myself in fusion to fit it perfectly.

1033660
1033661
 
This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top