Rexim Favor SMG - SE-14 Blaster

[Lichtbringer]

Has anyone here the definite diameter of it´s main receiver tube?

I searched a lot, but didn´t find much info on that gun.

 

[Panzer]

Wish I could help you, but I built mine from Hasbro blasters. I'm sure someone has the info though.

 

[Dann]

It's about 1.5 in.

I've got a resin cast in hand and I'm getting 1.450", I figure there may be some shrinkage but I can't be sure.

 

[Lichtbringer]

Wish I could help you, but I built mine from Hasbro blasters. I'm sure someone has the info though.

The very idea counts, too ..... thanks.

 

[Lichtbringer]

It's about 1.5 in.

I've got a resin cast in hand and I'm getting 1.450", I figure there may be some shrinkage but I can't be sure.

Thanks Dann.

If we go for 1,5, due to shrinking, that would be 38x1,5mm tube - the same as the Sterlings. So i only need to order steeltube in one size. :cool

The big question is - how good is the info that was used to build the master for the resin-one? As far as i know Morgan used a handcrafted master (very good job, wow), no real gun, to cast his version. Was his build accurate sized due to the use of real Rexims measurements, or scaled/calculated from other pics?

 

[morganthirteen]

The tube I'm using for the new version I've got underway is a 16th of inch less than 1.5 inches in diameter. With the dust cover on it (which only covers 2/3rds of the exposed circumference), it's exactly 1.5 inches.

 

[Lichtbringer]

The tube I'm using for the new version I've got underway is a 16th of inch less than 1.5 inches in diameter. With the dust cover on it (which only covers 2/3rds of the exposed circumference), it's exactly 1.5 inches.

Thanks Morgan, i was hoping for you chiming in.