Resins+EVA Foam (Australia based)-Can't get typical stuff, looking for sustitutes

ScorpionTR

Active Member
Hey so I've been researching a lot on the sorts of resins one would use on EVA foam to seal/harden/prime a build. Normally I'd straight away get the Epsilon or Smooth On 65D as recommended by Punished Props but they aren't really sold here in Australia and they are expensive to order online. I don't suppose anyone from Australia(or just anyone super-knowledgeable on this stuff) who uses these forums could recommend me some substitutes?

It's really overwhelming.
 
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top