Resin for Casting Warhammer Stuff?


New Member

3D modeller here who's new to figure modelling, and I was wondering if anyone could point me in the right direction for picking an appropriate resin to cast with? I've already done some research but I don't know what stuff will be too weak (e.g breaks if I drop it) or too strong/expensive (it would win in a fight against a wall).

What I plan on making are mod pieces for my Warhammer 40k army, and any assistance would be greatly appreciated!
I've been copying 40k minis using Smooth-on's Smoothcast series for a while now. I mostly do Ork stuff so the detail is chunky and relatively easy. I've played around with Marine and Necron stuff but they're generally too thin for me since I don't pressure cast.


This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.