Resin Airsoft BREN TEN

Jedifather

Sr Member
RPF PREMIUM MEMBER
I finally went and did it. I made a mold of my Airsoft Bren Ten. Here's how it came out:

resinbrenten01.jpg


resinbrenten02.jpg


resinbrenten03.jpg
 
I'm thinking of molding a airsoft pistol as well. Is it recasting? Ethics? How much would/could you sell castings for?
 
Fantastic work!! Those resin castings look great! Wish I could get hold of one of them in the UK...would look great in a MV display
 
This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top