Resin/3D printed or Cast metal ANH DL-44

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.


sdhlaw1701

Active Member
Looking for opinions. I want to do a Denix base ANH DL-44 display piece. Should I go with resin/3D printed parts or cast metal (like DEC's parts)? I have never worked with metal before so I don't know if that makes a difference. And I have never blued anything so I will probably paint the parts. Thoughts and advice is appreciated. Thanks.
 

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

Top