REQUEST: Iron Man Arc Reactor Mark VI (only the 3D-model, suitable for 3D printing)

GlennTech

Active Member
Hello,
I'm attending a workshop in about 2 months were they learn you to use electronics (I already know electronics just doing it for the free 3d-print) and 3d-printing. I may make 1 3d-model and I would like to make an arc reactor.
I'm not very experienced with 3d software packages.
Could someone make it? Maybe if I may make 2 arc reactors then I'll send one to you as prove of goodwill :).

If you feel like you're the right man on the job, please PM me.
Note: I want to make it a bit functional, I'll give further instructions through PM or just replying to this thread.

Thanks.
 
This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top