Repainting A Latex Mask

XilianX2010

XilianX2010

New Member
Well I've decided I want to repaint my predator mask, instead of layering more paint on top of it. I was wondering, do you guys just scrub it with warm soapy water to remove the paint? I have a seal on it, but the paint slightly cracks when the latex is bent or flexed. I really want to make sure I do it right so I don't rip the latex or ruin it if I do it wrong. 

It was done with Acrylics, and I have a thin layer of gloss seal on it.
 
This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top