Remove Beer Tab from Roman’s Graflex

Has anyone tried removing the beer tab from a Roman’s Graflex? If so, how did you do it?

I’ve seen guys tape off around the rivet, grab the rivet with some pliers and wiggle it side to side until it breaks free

I take the whole flash apart, and file the rivet from the inside

A little filing and the tab falls right off, and I don’t have to worry about slipping with the pliers and scratching the flash
 
I’ve seen guys tape off around the rivet, grab the rivet with some pliers and wiggle it side to side until it breaks free

I take the whole flash apart, and file the rivet from the inside

A little filing and the tab falls right off, and I don’t have to worry about slipping with the pliers and scratching the flash

Sounds good. Thanks for the tips Halliwax
 
This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top