Reply to thread

Message: <blockquote data-quote="SuperNovaSonya" data-source="post: 3544789" data-attributes="member: 134681">I'll try getting my hands on ABS, it does seem like the better option.  At this point I don't have too much of a choice though since I bought a lot of thin Plexiglas which was on a great sale (It's not really a waste if it doesn't vacuum form well because I can just use them for visors and whatnot later).My concern about fiberglass is that since it does have an exothermic reaction, i think it MIGHT deform my plexiglass molds.  I'm crossing my fingers and hoping that it won't, so that I can use all these plexiglas sheets now instead of watiting a week or so to pay for those ABS sheets to ship here and start vacuum forming all over again.I'll post a picture of the molds before and after the fiberglass reinforcement is applied. wish me luck.</blockquote>

This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

Your new thread title is very short, and likely is unhelpful.
Your reply is very short and likely does not add anything to the thread.
Your reply is very long and likely does not add anything to the thread.
It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
Your message is mostly quotes or spoilers.
Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
This thread is locked.