Rare Earth Magnets

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

Preds

New Member
So, indeed obviously from the title you know this is about rare earth magnets, and the big questions of all would be. Would they destroy the mask if you put the magnet "Under" the mask, not on top. I'v seen some that are on top of the mask, however i dont really want this cause i intend on showing the mask, without having big silver things attached to me. Since the bio is fairly heavy i know rare earth is usually in need, i just need to know if they are too damn OP to where it will start cutting through the mask. This would make my day, a very bad day, and thats never good. If all fails. Velcro FTW. i wouldnt wana go down that road but if i have to. SO BE IT

Thanks. For any info reguarding the situation.
 

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

ptgreek

Active Member
because of the strength of the magnet, you could glue in a buffer between the magnet and the mask ...a strip of fun foam will work ....thats what I did ...never had a problem ...actually, I think there is even some polyfoam between the mask and the magnet as well ...damn ..these magnets are strong
 

Ei luj

New Member
You got that right, George, they are STRONG (and they pinch!)

Preds,

You can put fabric between the magnet and the mask, and over it to hold the magnet in there, Barge cement works well.

Same with the bio, here you could epoxy em in, and cover with a liner of fabric.

---
Ei'luj
 

Elkman

New Member
The magnets I got at the craft store had rounded edges, so I didn't have to worry about them cutting through the mask. And actually, I didn't get my magnet glued onto the mask properly, either. I used CA adhesive, but it apparently didn't stick to the magnet. Or, the sweat from my scalp combined with the tugging at the mask may have dislodged it. In any case, the magnet fell off part way through the evening.

So, you'll probably have to worry more about keeping the magnet attached to the mask than about the magnet cutting through the mask.
 

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

Don't want to see this ad? Sign up for anRPF Premium Membershiptoday. Support the community. Stop the ads.

Top