Question about Snape's wand


New Member
I am going to try to make a wooden replica of Snape's wand. But I have some questions. Imneed to know the lenghth of the handle and the part at the end that starts to becomes some what pointed I have a picture incase you are confused.


By the way the image I drew on was not mine I got it off of Google Images
From the measurements of an NC Snape wand I had some time ago, the entire handle was just under four inches, and the conical bit on the end was a bit over half an inch.

However, I know these measurements are not nearly as precise as some other members here could provide.
This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.