Q: punching holes in EVA; which tool?

Marnok

New Member
So, I want to punch some small neat round holes in some EVA. Regular hole-punches are no use; different size, can only insert foam up to hinge and no deeper, cut is often warped, etc.

So I am thinking there must be something I can line up and tap with a hammer ,but I'm not seeing anyone using them in vids andweb searches haven't shown me anything.

What should I be using? I am considering heated drill bits and all sorts, but I thought, I bet everyone else knows a good method and I'm just not finding it.
 
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top