Project Triforce is making a M8 Avenger from Mass Effect 3

I saw this a little while ago when they first announced it, but far too rich for me. Their GOW3 COG snub blaster is really tempting though!
 
I saw the prototype at SDCC last year. It was good, really good actually. But at that price I'm more inclined to try and make one myself.
 
Nearly all polystone...yep! .... very heavy. I got one. :loveOK for display on a rack or wall...definitely not cosplay. :unsure
Hmmm?.... polystone is a good detail casting material, but for a gun?
It is strong but brittle upon impact loads, almost like ceramic so you just gotta not drop it for sure.:confused
Not into Mass Effect gaming, but I like the "artwork" design and some of the costume, spaceship and weapon designs in Mass Effect. Got my sights on other rifles in Mass Effect as well. :cool
 
their M8 is 36 inches long! I have an offical source from bioware who informed me that it is roughly 30.5-32 inches long in actuality.
 
their M8 is 36 inches long! I have an offical source from bioware who informed me that it is roughly 30.5-32 inches long in actuality.
Yep... I measured the Triforce M8 replica I have. It's 34.5 inches long. Not bad. Don't mind the length.... it's the freeking weight!!....sheeesh too heavy to hold (20 LBS or so), but OK for display on a wall or rack only.
30 to 32 inch range would be cool too.
:cool
 
Last edited:
This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top