Predator Undermask/face Mold Help

BoSkarr

Well-Known Member
I need help with how to make a mold for a Predator undermask with mandibles.
What is the best way to make a 2 part mold for this, without damaging the mandibles?

my dad wonders if making the mandibles from wax and heating it up in the mold and melting them would work.
Please post suggestions.
 
if it's not a half mask you have to mold the mandibles seperate ,...otherwise air gets trapped in the mold and they don't cast right anyway ,....
most people seperate the 2 halves of the mold right around the first or second layer of dread holes ,....easy spot to hide the seam ,....
 
[quote name='Bo'Skarr' timestamp='1351988952' post='359103']
okay, thanks.
[/quote]

no problem man ,......it's def worth getting the mold perfect otherwise you ruin a sculpt and ruin a bag of ultracal so ,...hahah
 
This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top