powering my revamped Spirit Proton Pack


Well-Known Member
My full sized packs are all powered by a Makita 12v battery down the booster tube, so after i gutted, modified, and repainted (for funzies) a spirit pack , i wanted to use an easily changeable/rechargeable power source. The booster tube on a full sized pack will easily fit a makita flashlight, which i used for the battery recepticle, but it wont fit the spirit pack. With my very elementary Tinkercad powers i designed and printed a new booster tube that accepts the makita battery...i haven't painted the top of the battery yet , sorry


  • thumbnail.jpg
    164.9 KB · Views: 23
  • thumb4nail.jpg
    101.1 KB · Views: 24
  • 2.jpg
    90.8 KB · Views: 28
  • 1.jpg
    85.1 KB · Views: 25

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.