Power Rangers Zeonizer refurbishing

Discussion in 'Replica Props' started by Teamelite, Jun 14, 2015.

  1. Teamelite

    Teamelite New Member

    Trophy Points:
    2
    Hey all, been a while since ive posted. Anyway, Ive recently aquired a power rangers zeonizer that Im looking to refurbish. The first objective I have is to switch out the red LED in it to a white while trying to get other colored crystals made for the other half. Ive tried a few tests with a white LED in place of the red and am not having much success. Any suggestions? below is a pic of the setup. One of the wires did break as I was opening it but managed to figure out where it connects. I can provide a photo of the backside of that board to show the other parts. Thanks.[​IMG]
     

Share This Page