TK1625

Well-Known Member
Hello everyone.

I was asked to paint up a Porkins helmet. This was my first time even trying to attempt such a design. I’ve seen a few different decal sets, but felt that using only decals took away too much freedom in order to make adjustments based on the size of the helmet. So I used a bit of both.

I painted the red on the front and the green around the rams horns. Green? I know right? But the pics I found here seems to show it being a type of green. I talked with the client and he made the final call on the color and therefore, green it is. The rest is decals. Everything was hot with a clear coat before weathering.

After working on this, I think I’d like to add a Porkins to my collection. Any thoughts, comments, recommendations, or critiques would be appreciated. I know the helmet isn’t 100% accurate, but certain liberties were taken and approved by the client.

thanks for any input.
71B9CC30-A6B3-45E4-B902-394D1EC84574.jpeg
FA97A599-AA9B-4C48-84A7-DACDC59D65B7.jpeg
4604A75C-1FF1-4DFF-BA04-0A07DD1FD03D.jpeg
EE60415A-8E80-457E-B3D3-1B3AF1D16F00.jpeg
DAB54352-E04B-4740-A3BD-A57FE52FFDB7.jpeg
228DFBA8-1188-4E00-BF38-33D79F8E6E81.jpeg
C1355A12-28C4-47B4-866E-C3E56708A52B.jpeg
 
This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top