Pirates of the Caribbean Talking Skull - UPDATED V2

[tradersam]

Well, I finally finished it! The skull is angled down where it shouldn't be, but it looks good since it is mounted so high to the ceiling. This replaced my hand-sewn Jack Sparrow jolly roger flag; now I have to find a place to display that.

​

Of all of the 3D-printed parts, the only thing that I didn't make from scratch was the skull(s).

The drapery pieces are 45-inches square, which is the perfect length for the width. The length, however, was far too long; I had to fold the bottom of the fabric before I gathered it.

 

[brygphilomena]

Well, I finally finished it! The skull is angled down where it shouldn't be, but it looks good since it is mounted so high to the ceiling. This replaced my hand-sewn Jack Sparrow jolly roger flag; now I have to find a place to display that.

View attachment 1573452

View attachment 1573453
​

Of all of the 3D-printed parts, the only thing that I didn't make from scratch was the skull(s).

The drapery pieces are 45-inches square, which is the perfect length for the width. The length, however, was far too long; I had to fold the bottom of the fabric before I gathered it.

Where did you get the STL for the skull end caps of the curtain rods? I'm starting a build myself of one of these and I've already found your 3d models that I'll be purchasing shortly.

 

[TJackFx]

…removed