Frogfreak

Sr Member
Hey everyone, this is my first serious try at a palpatine sculpt. The whole idea is that currently it's a smaller palpatine face sculpt to see if I can get the details right. Later when I'll get the supplies I'll be doing a life-cast of my head and then sculpt the details with my oil-based clay. After that I'll mold it and then cast it with a foam latex substitute. So, let's where this goes!

Not much right now, but I'll have more pics soon! (Forgive the bad pics!)
One without the hood
received_324467918795177.jpeg


And one with!
received_699126977340398.jpeg
 
Alright guys, I think I'm finished doing anything with the small sculpt I've been working on. it was mostly a test to get a good likeness, and I think I did decently! (Plus I think I'll do better on the bigger one) So, I may do a small cast of it or something for myself, aside from that it's done. Next up I'll be doing it on a life cast of my head! (Which has yet to be done! :lol: )

Anyway, two lil' pics of the finished mini sculpt.
received_739230676809896.jpeg
received_1021205821662887.jpeg
 
This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top