I've got the snow preds cannon painted up and am looking at ways to mount it on the shoulder, but I'm kind of lost. If anyone has a P2 system, could you post pics of the set-up for the cannon...I'd appreciate it!
Have you tried using screws with flat washers and also using glue as a (BACK UP) with the screws? You might have to place a flat piece of plastic against the underside if the latex and then place the screws through the plastic into the latex going into the arm. The plastic will give the screws something big and flat to hold to and wont slip threw the latex holes. i.e. a used piece of plastic about 2 inch square from a butter bowle would do the trick. Then you could tighten the screws down.well ran into a snag. I got the arm attached but connecting the base to the suit proved to be a problem. Since my P2 armor is latex it is too flimsy for something of that weight and makes the cannon flop around to the point it wants to fall off. My roommate and I just spent the better part of 2 hours trying different ideas from wrapping string around it to mounting it on the back instead of the shoulder etc but came up with nothing that worked well enough. So at this point i'm open to ideas.