P1 bead measurements?

Thread starter vgfett
Start date Jun 29, 2010

vgfett

New Member

Jun 29, 2010

I'm going to go with the Rubies upgrade thread to make my beads, and it's mentioned that copper pipe was used. Can anyone tell me what the standard length and diameter of the beads should be?

This thread is more than 13 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.