Unlimited Run Opening Reverse and Regular Flash Ring


replicaprops

Official Licensee
RPF PREMIUM MEMBER
I made this because in the show it obviously looks like it should open. I decided to use off the shelf hinges and magnets so it could be easily assembled by anyone.
Right now I only have 1 size (size 16) which should fit over a glove .
The compartment inside is 15.5mm x 12mm x 1.2mm deep. So you could put a micro sd card in it or make a micro flash costume.
CLICK HERE TO ORDER THE BASE
CLICK HERE TO ORDER THE REVERSE FLASH TOP
CLICK HERE TO ORDER THE REGULAR FLASH TOP

Here is the magnets you need

Here is the hinge you need, select the 06mm from the drop down menu

version 2 assembly.jpg version 2 assembly1.jpg version 2 assembly2.jpg

version 2a assembly1.jpg version 2 assembly1.jpg version 2a assembly.jpg
Have fun with it.
Rob
 
This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. Your new thread title is very short, and likely is unhelpful.
  2. Your reply is very short and likely does not add anything to the thread.
  3. Your reply is very long and likely does not add anything to the thread.
  4. It is very likely that it does not need any further discussion and thus bumping it serves no purpose.
  5. Your message is mostly quotes or spoilers.
  6. Your reply has occurred very quickly after a previous reply and likely does not add anything to the thread.
  7. This thread is locked.
Top