Oblivion Elder Scrolls IV: Imperial Guard Helmet Build

[Xtremenoob]

So the helmet that was on my to do list was the Imperial Guard helmet from the game Oblivion, which is the forth installment for the Elder Scrolls franchise. So my end result was to mold and cold cast the helmet. My theory was to 3d print then just work with the normal bodyfiller but realized that the helmet would be a bit perfectly shaped/curved so i decided to use epoxy sculpt and flatten out as best as i can then repeatedly hit it with a old meat cleaver so create all those little holes and dents to replicate the texture the helmet has.

So any way this is currently where i am at but the rest of the pics and vids are of the build.

Current state

Oblivion helmet by daniel.bignoux, on Flickr


Build pics and videos

004 by daniel.bignoux, on Flickr

170239_full by daniel.bignoux, on Flickr

002 by daniel.bignoux, on Flickr

003 by daniel.bignoux, on Flickr

004 by daniel.bignoux, on Flickr

008 by daniel.bignoux, on Flickr

009 by daniel.bignoux, on Flickr

007 by daniel.bignoux, on Flickr

004 by daniel.bignoux, on Flickr

002 by daniel.bignoux, on Flickr

3D MODEL

BUILD PART 1

Build Part 2

Molding and casting

Part 3

So until the next update which i do not know when there will be one unless i start a insterest thread to help fund the molding and casting
Well Until then
Daniel

 

[Xtremenoob]

Just and update, these are going in the junkyard section

Oblivion helmet by daniel.bignoux, on Flickr

Oblivion helmet by daniel.bignoux, on Flickr

Oblivion helmet by daniel.bignoux, on Flickr

Oblivion helmet by daniel.bignoux, on Flickr

Oblivion helmet by daniel.bignoux, on Flickr

Oblivion helmet by daniel.bignoux, on Flickr

Oblivion helmet by daniel.bignoux, on Flickr