Krest
Well-Known Member
Today I 3D-printed the Nur-Ab-Sal Necklace from Indiana Jones and the Fate of Atlantis Game.
The file is from Thingiverse and though it's not "screen accurate" It's still a nice file.
It's printed in Colorfabb's CopperFill filament which contains copper paricles and can be buffed and oxidizes.
Here's the print after some smoothing with a soft brass wire brush:
And here it is after one hour covered with a wet paper towel soaked in a vinegar and salt solution:
I'll leave it over night and will show you the result tomorrow.
The file is from Thingiverse and though it's not "screen accurate" It's still a nice file.
It's printed in Colorfabb's CopperFill filament which contains copper paricles and can be buffed and oxidizes.
Here's the print after some smoothing with a soft brass wire brush:
And here it is after one hour covered with a wet paper towel soaked in a vinegar and salt solution:
I'll leave it over night and will show you the result tomorrow.