New Used 7 Days Set up & Painted 1:2 Scale AVP Celtic Predator Bust

sammycstsui

New Member
Hi Bros , I finished this today after using 42 hours. Below I have described a few painting processes to achieve the final look.

There was a little bit of excess material on the mould which i had to remove and mend before painting. I added 2 plastic dreads on each side by using a baby drill for added effect. Next I added the air pipes going into the BIO which are springs. The lenses looked really common before so I replaced them stainless steel netting. I also added hand knitted black netting to the predator body to make it look more dramatic. For the armor I normally use a dark finish to begin with and then lightly brush the chrome silver onto the armor surface and then brushing it off gently to resemble the worn armor effect. The skin colours used were referenced from the movie and added spots were also done by myself. The colour used for the dread, matte black, also the rings on the dreads were painted in the same way as the armour using the brushing technique for the bronze effect.

Now pre-order post on buy and sell

DSC03349.jpg


DSC03350.jpg


DSC03352.jpg


DSC03353.jpg


DSC03354.jpg


DSC03355.jpg


Reduced: 80% of original size [ 640 x 480 ] - Click to view full image
DSC03356.jpg


DSC03359.jpg


DSC03360.jpg


DSC03361.jpg


DSC03363.jpg


DSC03364.jpg


DSC03365.jpg



Thanks for your visit !

DSC03349.jpg


DSC03350.jpg


DSC03352.jpg


DSC03353.jpg


DSC03354.jpg


DSC03355.jpg
 
Last edited by a moderator:
This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top