New P1 Bio from Hez

Tony Hughes

Active Member
Ok so i managed to get one of hez's cold cast aluminium 2nd gen p1s.
First things first and that is that i love this bio! Thanks again Paul!
Secondly i completely forgot to take a photo as it came out of the box!!! but the first pics i have here i have only just begun to sand slightly and polish in a few ares i wanted shiny.
The next photos are after i had drilled out the cheek port hole and laser area. I have also installed the lenses which i based on what Mr Paul Fransis says are the real lenses used in the film. These things are a B**** to make!
Ive got a light smoke plex, then two way mirror film, then wire mesh and then finally dark smoked plex!
from the outside they just look like a mirror untill you get it in the right light, then they look awsome! I cheated in one of my photos and put my iPad behind the bio so i could capture the mesh but you get the idea.
So Mr Fransis thank you for the thread on the lenses as they really look great!
Ive still got quite alot i want to do to this one so ill be updating as i go from now on.
Thanks for looking guys hope you like it :D

IMG_0396.JPG


IMG_0403.JPG


IMG_0405.JPG
 
This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top